First sign - Oramask failure - Finished Projects - Onefinity CNC Forum

It’s not much, but it’s a start. I had a hard time with the Oramask, so I went with just painting and then doing a .005 skim cut and it worked pretty well. Will use as a lazy susan on the table during Christmas season. I do want to figure out how to make the Oramask adhere better. Is there a downcut V-bit available? It would help if the bit wasn’t pulling the masking up during the cut.

Hard Limit Alarm and Homing Error - Troubleshooting (Elite Series) - Onefinity CNC Forum

Post up them projects - Finished Projects - Onefinity CNC Forum

Homing problems - Troubleshooting (X35/X50) - Onefinity CNC Forum

R.I.P. Onefinity CNC - Troubleshooting my $3000 paperweight

Post up them projects - Finished Projects - Onefinity CNC Forum

V1 Engineering Inc -V1E.com

Help! Losing “Home” during carves - Onefinity CNC Forum

First Sign and Coasters - Finished Projects - Onefinity CNC Forum

Crooked ProjectHelp! - Onefinity CNC Forum

Movement issues - Troubleshooting (X35/X50) - Onefinity CNC Forum

Lots of Wonderful Signshas anyone used their CNC for something other than signs? - Finished Projects - Onefinity CNC Forum

Is it possible to tram X/Y squareness with fixed feet? - Troubleshooting (X35/X50) - Onefinity CNC Forum

Lots of Wonderful Signshas anyone used their CNC for something other than signs? - #60 by AndyP - Finished Projects - Onefinity CNC Forum

Machining fixtures making short-run production a piece of cake - Onefinity CNC Forum

Lots of Wonderful Signshas anyone used their CNC for something other than signs? - #78 by deltatodd - Finished Projects - Onefinity CNC Forum