Do I have a problem with adhesion? I'm trying to print a Golden Snitch wings, I managed to make one, but the other attempts were all failures The last pic is a

English Oblivion Society, PDF

This is one of my first ever resin prints on my Anycubic Photon M3 Max, resolution is 7K and layer height is 0.01mm, I'm really excited. : r/resinprinting

This watercolor painting features a golden snitch from Harry Potter and a banner with the phrase snitches get stitches., This listing is for an

Snitches Get Stitches Harry Potter Golden Snitch Watercolor Print

Can't make any prints on my VoxeLab Proxima 6. : r/Voxelab_Proxima

Rolling Thunder - CrimethInc

Can't make any prints on my VoxeLab Proxima 6. : r/Voxelab_Proxima

I'm printing out every Pokémon in 1mm:1in scale and painting them. Here is part 2, #0001 - 0051! : r/pokemon

Your Birth Certificate Is Not A Bond., PDF

Do I have a problem with adhesion? I'm trying to print a Golden

It's okay to be scared. But you have to get out there, open up

I'm printing out every Pokémon in 1mm:1in (1:25.4) scale and painting them. Here is part 3, #0001 - 0082! : r/pokemon

3D Printed Golden Snitch : 4 Steps (with Pictures) - Instructables

First layer went down great. When i came back, the bottom half of my print was wavy. Any ideas? (No supports is a different issue, and a slip-up on my part. Woops!) Printing on an Ender 3 V3 SE on stock firmware, printing PLA at 250 mm/s. I just

Can't make any prints on my VoxeLab Proxima 6. : r/Voxelab_Proxima