Oramask peeling off paint or something else? - Projects

I primed the MDF, painted, sanded and painted again. I masked it with Oramask 813 and then cut. After the cut, I sprayed with primer and let it dry for a few hours. When I peeled the mask, this is what happened. I’m not really sure why it did that. I’ve done the same process before with no issues. The only difference I can think of is that the mask was on longer than normal because I had a belt break near the end of the cut and finished the next day. I’d appreciate any thoughts.

Hi everyone, has anyone tried Oramask to engrave on a cnc? Its been a disaster for me ☹️… any tips? : r/CNC

Using Oramask 813 as a Reverse Stencil - Expressions Vinyl

How to use oramask stencil and free cut file - A girl and a glue gun

How to use oramask stencil and free cut file - A girl and a glue gun

Oramask 813 for CNC Work – Martin Woodworking

For use with any smooth, flat surface, from wood to glass to vehicle surfaces! Suited for use with water based and latex paints. Translucent

ORACAL 813 Oramask Paint Mask 24 Inch Stencil (24 Inch x 10Yrds (30ft))

1 Roll 12x 50 Yards Oracal 813 Oramask Stencil Vinyl

ORAMASK - Application & 2 Color Paint Job

How To Use Oramask 813 Stencil Film For Painted CNC Signs

How to use oramask stencil and free cut file - A girl and a glue gun

Carve through spray mask - Inventables Community Forum

How To Get the Best Results with Oramask

Secrets to a Perfect Hand Painted Sign With a Vinyl Stencil - Daily Dose of DIY

How to use oramask stencil and free cut file - A girl and a glue gun