Is my extruder too tight? My extruder gears are damaging my filament. What could I do to solve this problem? Should I loose the spring? : r/ender3

Is my Pro 5 extruder spring too tight? PLA 1.75mm. : r/ender5

Installed new extruder, but wheel is touching gear Is that an issue? : r/ ender3

Dual gear extruder too tight even when as loose as possible? (info in comments) : r/3Dprinting

Extruder Tension Calibration Guide

Crap filament, extruder too tight or something else? : r/FixMyPrint

Is my extruder too tight? My extruder gears are damaging my filament. What could I do to solve this problem? Should I loose the spring? : r/ender3

My extruder keeps cutting my filament!? Help please? : r/ender5

I think my extruder gear is worn, but it's pressured on. Does my gear look like the problem? wanna ask before I have to buy a new extruder : r/ender3

Everything about Extruder Pre-Tension!

Redrex Dual Gear Ender 3 Extruder with Two Washers Metal Drive Feeder Upgrade Kit Compatible with Creality Ender 3 V2 Pro,Ender 3 Neo Series,CR10 3D Printer TPU Filament Supported(Motor Shaft>21.5mm)

How to loosen tension? : r/ender3v2

Is my extruder too tight? My extruder gears are damaging my filament. What could I do to solve this problem? Should I loose the spring? : r/ender3

Extruder spring tension mod : r/ender3v2

Ender 3 Neo: Extruder is Loose or Wobbly? 5 Second Fix!

Possible solution to your sprite pro behaving and or under/over extruding problems. : r/Ender3S1