Peeling Winder Connector Power Tool Accessories Parallelizer Wire Twisting Wire Twisting Tool Cable Connector Stripper Winder Twister Power Drill LENGTH TO 2.5 SQUARE METERS

4.7

(621)

Write Review

$ 6.00

Add to Cart

Qty

In stock

Description

Buy Peeling Winder Connector Power Tool Accessories Parallelizer Wire Twisting Wire Twisting Tool Cable Connector Stripper Winder Twister Power Drill LENGTH TO 2.5 SQUARE METERS at

Made of high-quality 45# stainless steel, with good performance.
Two screwdrivers are included for manual tightening and peeling.
The wire connector tool with 3/8 inch hex handle can be connected to impact drivers and electric drills.
The stranding tool can be twisted and stripped at the same time, which helps to increase productivity and prevent finger soreness.
The wire connector tool can be used not only for electric drills, but also for manual use.
It is easy to operate and helps reduce repetitive sports injuries.
Product Type: Wire Stripper
Material: 45# steel
Color: silver
Instructions for use:
Electric parallel:
Prepare the hand drill and connect the liner to the hand drill.
Insert three parallel wires separately, fix the tail with a vise, and install the threader and vise as much as possible. The three wires must be clamped. If not clamped, the connection will be affected influences.
Start the electric drill to start the electric drill, and then slowly rotate the aligner. During the rotation, align the aligner vigorously in the vise direction. After winding, the aligner can be adjusted
Loosen and remove the wires, wires.
Manual parallel:
Measure the length of the strip to be peeled off.
Put a lot of wires into the corresponding holes and clamp them in a vise.
Press the parallelizer in the direction of the arrow to rotate and parallel.
Do it in parallel.
Note:
Clamp the wires with pliers. The wires must be parallel and secure.
The pliers are in close contact with the parallelizer.
Package Included:
1 * Wire stripper