RF-5215 PVA Mold Release Agent

RF-5215 is a water-soluble parting film (PVA) recommended for separation between polyester, epoxy and polyurethane resins from various mold surfaces.  It is typically applied by a siphon cup spray gun.  After the part has been separated from the

Release Agents - Wax - PVA - Semi-permanent

PVA Release Agent

Partall One-Coat is a polyvinyl alcohol (PVA) coating that contains 2 – 3 times the solids content of standard PVA giving it a thick viscosity that

HGB Partall One-Coat (PVA) Purple Mold Release Gallon

Release Agents - Wax - PVA - Semi-permanent

Polymers, Free Full-Text

PVA, or polyvinyl alcohol, should be used with our #1016 Partall Wax for the easy release of parts from a mold. Wax should be applied to the mold, 3–4 layers thick, and buffed to a high gloss. Once the final layer of wax has dried, PVA should be applied with the following considerations:PVA can be brushed on, but for best results, apply with a spray gun, 12–18 inches away from substrate. Generally, apply in three layers: the first, a thin mist, allowing 10-15 minutes to dry completely.

Fibre Glast - PVA Release Film

Release Agents - Wax - PVA - Semi-permanent

Release Agents - Wax - PVA - Semi-permanent

Polyvinyl Alcohol (PVA) Mold Release & Air Dry Agent

PVA Water Based Mould Release - Polyvinyl Alcohol Agent for Epoxy, Polyester, Vinyl Ester, Resin, Gel Coat, Polyurethane Foam, Silicone- Spray or Brush-On Film for Sculpture and DIY Projects : Arts, Crafts

👍 EFFORTLESS MOLD RELEASE - Having a tough time taking projects out of its mold? This PVA release agent forms a barrier between the parts and mold

PVA Water Based Mould Release - Polyvinyl Alcohol Agent for Epoxy, Polyester, Vinyl Ester, Resin, Gel Coat, Polyurethane Foam, Silicone-Spray or