Narex Marking Knives - Classic Hand Tools Limited

The Narex marking knife is an essential tool for creating marks on wood when laying out precision joinery or transferring measurements. The flat handle profile prevents the knife from rolling off the bench.

With the addition of laser cut finger indents which are useful for applying pressure closer to the tip.

Available in three thicknesses; 2.5mm, 1.2mm, & 0.75mm

Handle: Polished Rosewood with brass pins

Blade: Stainless steel, hardness 57 HRc

Blue Spruce Toolworks

Why You Should Buy a Marking Knife

Narex marking knife with finger indents Essential tool for marking wood when laying out precision joinery or transferring measurements. These improved

Narex marking knife with finger indents • The Woodworking Club

Narex Marking Knives - Classic Hand Tools Limited

Narex Marking Knife With Finger Indents • The Woodworking Club

Dual Double Bevel Striking Marking Knife With Blade From Hardened

Pfeil Small Double Bevel Marking Knife (AM K)

This is a left hand marking knife made by Narex Tools of the Czech Republic. This knife will draw a much finer line on wood than an awl or pencil. It is beveled on one side only to keep the cut absolutely tight to your rule or square. Defines an exact line for starting a chisel or saw blade. Designed to draw a line on the left side of a rule. Made from super hard tempered and hardened high speed steel. Will take and hold an excellent edge.

Narex Right Hand Marking Notching Violin Knife (813701)

Marking knife with finger indents Narex, carpentry knife

BENCH MARK KNIVES ・Diamond Back

Wood Chisel Buyer's Guide For Woodworking

This carving/marking knife is made by Narex of the Czech Republic. Blade is made from highly allowed Cr-Mn steel and heat treated to HRc 58. Handle is of European Beech with an octagonal cross section and 4.125 long. Blade is super thin at 0.075 thick and 0.380 wide and 2.75 long. Dual bevel sharpened at 7 degrees on each side. This knife will easily fit in the tightest of dovetails. Knife comes super sharp and ready for use. This knife an excellent value for a good quality tool.

Narex Czech Steel Super Thin Dual Bevel Dovetail Carving Striking Marking Knife with Hardened Cr-Mn Steel Heat Treated Blade to HRC 58 813900