Hello, I’m trying to make earring cards with text engraved on it and sometimes it engraves okay, other times it’s missing chunks of letters. This was my very first try and it went perfectly! It was subtle enough and looked really good! Next, it didn’t go so well. I tried engraving 4x with the same settings and you can see what’s wrong. Then I also tried all the other settings, but I can never get it the same as on the first picture. It either looks too dark and burned too deep or it miss
Accuracy in line mode - Ortur Lasers - LightBurn Software Forum
Lightburn engraving not producing accurate burns with Ortur Laser - Ortur Lasers - LightBurn Software Forum
Test Pattern for burning using Ortur LM2 - 15w Laser - Finished Creations - LightBurn Software Forum
Laser engraving on a slant - Ortur Lasers - LightBurn Software Forum
Ortur Laser Master: will not engrave at all - Ortur Lasers - LightBurn Software Forum
Ortur LM3 printing on angle - Ortur Lasers - LightBurn Software Forum
Photo Engraving (Very Inexperienced) - LightBurn Software Questions - LightBurn Software Forum
Laser runs but does not engrave - Ortur Lasers - LightBurn Software Forum
Laser starts engraving out of position - Ortur Lasers - LightBurn Software Forum
Ortur Laser 2 will come on but not burn - Ortur Lasers - LightBurn Software Forum
Problems engraving leather - Getting Started With LightBurn - LightBurn Software Forum
Newbie here. Imported art in LightBurn does not match the engraving - Community Laser Talk - LightBurn Software Forum
Ortur Laser Is burning squares instead of designs - Ortur Lasers - LightBurn Software Forum