Bison Epoxy Universal, Strong Dual-component Epoxy Adhesive, Transparent Epoxy Glue for All Materials and Surfaces, Water Resistant Material

This Glue item by PolymerClayLatvia has 29 favorites from shoppers. Ships from Latvia. Listed on Nov 15, 2023
Bison Epoxy Universal Product information: * Super-strong (up to 170 kg/cm²) * Resistant to temperatures between -30°C and +80°C * Filling * Water resistant * Chemical resistant * Paintable Suitable for: Ideal for repairs to metal, ceramics, porcelain, crystal, glass, ivory, pearls, precious stones and various synthetics (polyester, bakelite, formica, rigid polystyrene and acrylic glass) GETTING STARTED Before Use: Working conditions: only apply at temperatures between +5°C and +35°C. Product cures by mixing the resin and hardener. Personal safety: preferably wear gloves. Surface requirements: the materials to be bonded must be dry, clean, free of dust and grease. Preliminary surface treatment: degrease parts to be bonded with acetone. Roughen smooth surfaces (sandpaper). Tools: mix the components in the double-syringe by means of the supplied mixing bowl and spatula. During Use: Handling of packaging: remove the spatula from the side of the double syringe, and the closure cap from the handle. Break the seal of the double syringe. Directions for use: Press out an equal amount of both components onto the enclosed mixing tray. Mix these two equal parts well with a synthetic spatula until a mixture is obtained with a homogeneous colour. Apply the mixture, which at room temperature (+20°C) remains toolable for about 1.5 hours, as a thin layer on one of the two materials. Join the materials and keep them in place for 7 hours. Be careful not to move the parts before the adhesive has cured. After use, clean the nozzle with a cloth and place the special cap in the handle on the double syringe. Resin and hardener must not come into contact with each other unless for usage. Advice: Some types of synthetics can not be joined such as polyethylene and polypropylene. This can be tested by holding a glowing copper wire against the synthetics. Does it smell of wax? Then you can not bond it. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing. Points of attention After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5°C. After Use: Stains/residue Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically. Storage conditions: Store cool, dry, frost-free, upright (nozzle upwards) and tightly closed.

Bison Epoxy Universal, Strong Dual-component Epoxy Adhesive, Transparent Epoxy Glue for All Materials and Surfaces, Water Resistant Material

Poly Max glue for bonding and sealing Cremation Ashes Urns

Jewelry Epoxy Glue

Polymer Clay Bison

Bison Montage kit Cotact Adhesive Universal Adhesive Plastic Adhesive EPOXY Glue

2PC/set Super Strong Epoxy Clear Glue AB Adhesive Acrylic Structural Adhesive for Cold Weld Plastic Metals Glass Rubber - AliExpress

Epoxy For Knife Making: A Complete Guide - Red Label Abrasives

Bison Glass Art

BISON EPOXY Crystal Clear 5 Minutes Fast Two-Component Epoxy Glue Adhesive: : Industrial & Scientific

Two-component Epoxy Glue Logo Epoxy Fast 34ml - Best Shop