Custom 10x10ft Canopy Tents

4.9

(95)

Write Review

$ 381.50

Add to Cart

Qty

In stock

Description

One of our best sellers! 10x10ft, Heavy Duty Aluminum Frame w/ Lifetime Warranty, Top, Back and Sides are all customizable, Easy Pop Up Tent Design, Single or double sided.
How to Set Up Your Custom Canopy Tent* Fasten Hook-and-loop adhesive to secure the canopy to frame (0:49)* Turn crank to extend canopy (1:17)* Back wall attaches using hook-and-loop adhesive (1:28)* Secure wall using hook-and-loop adhesive tabs (1:27)* Support poles connect using click-button assembly (1:55)* Single and double-sided walls available with optional door and windows (2:10)* Commercial-grade hexagonal aluminum frame with fiberglass reinforced connectors (3:00)* Hexagonal composition means a strong, sturdy frame (3:07)Step 1: Take your frame and slightly expand it open to expose the corner bars.Step 2: Take your canopy graphic and place it on top of the frame.Step 3: Place each corner of the canopy graphic and fasten the velcro connectors to the loop velcro on the frame.Step 4: Connect the center lift pole of the stand to the center of the canopy. There is a spot in the center that it connects to.Step 5: After you have connected each corner to the velcro loops and centered the lift pole to the canopy, expand your frame fully.Step 6: Push each of the corners up until you hear it latch, Slide the corner of the canopy down to cover.Step 7: Attach the velcro strap to the frame for support.Step 8: Expand each leg of the frame by pushing the red button down and pull the leg out to the desired height. Step 9: Take your back wall graphic and Velcro it on the top of the back wall and the back end of your canopy. Secure it by tying down the bungee cords.Side Rails AssemblyStep 10: Grab 2 of the larger poles and 1 small pole and connect them together creating 1 rail that slides through the pole pocket on the bottom of the Backwall graphic.Step 11: You will notice that there are 2different types of clamps for the rails, Flat top clamps and Triangle top clamps. Grab one of each of the clamps and clamp it around the frame's leg. The clamp should fit snug around the leg then slide the pole from the graphic and insert it into the clamp. Tighten the clamp with the screw. Repeat it on the other side.Step 12: Repeating Steps 10 &11, make 2 large poles to be used on the sidewall graphic. When placing the clamps on, make sure that the top clamp is above the leg clamp to add extra support. Do that for both sides of the canopy.Step 13: Once you have your Canopy all setup and ready, you can spin the center liftpole up until it is firmly in place.