GluBot 16 Oz Glue Bottle with Tips and A Gluing-Edge Guide

<h3>The FastCap Gl&uuml;Bot Glue Bottle was designed by professional cabinetmakers and woodworkers.</h3> <p>The Gl&uuml;Bot is easy to fill, it won't drip, and it dispenses glue in both a horizontal and a vertical position. It will be the best glue bottle you will ever own.</p> <p>The Gl&uuml;Bot is designed with a two-chamber system that pushes the glue from the bottom of the main chamber up through the secondary chamber which ensures fresh glue every time.</p> <h3>FEATURES:</h3> <ul> <li>Holds 16 oz of glue or other liquids</li> <li>Replaceable Tips &amp; cap storage</li> <li>Dispenses glue from the bottom first</li> </ul> <p>&nbsp;</p> <h3>INCLUDES:</h3> <ul> <li>(1) 16 oz. Gl&uuml;Bot</li> <li>(1) Glue Edge Guide</li> <li>(1) Flat Tip</li> <li>(1) Yorker (Thin Bead) Tip</li> <li>(1) Sealing Cap</li> </ul> <h3>Great for</h3> <ul> <li>Yellow glue</li> <li>Wood glue</li> <li>Other liquids</li> </ul> <p>&nbsp;</p> <p>The Gl&uuml;Bot is made out of polyethylene and is resistant to all solvents, except ones that are corrosive to that polymer or extremely high temps (80C+).</p> <h4>Is there a trick to keep the Gl&uuml;Bot from clogging up the nozzle?</h4> <p>Go slow the first few times you use the Gl&uuml;Bot. If you apply careful pressure when squeezing the bottle you should be able to get just the right amount of glue to dispense, and when you release the pressure it should suck the glue back into the bottle. If you squeeze too hard you will dispense too much glue which can coat the tip and cause clogs. Use a paper towel when you are done using the Gl&uuml;Bot to wipe off any excess glue on the tip, and then replace the red cap firmly to prevent air from reaching the glue. If you only use the Gl&uuml;Bot occasionally only put a small amount of glue in the bottle when you go to use it, and then wash out the glue bot with hot water when you are done. If you let the Gl&uuml;Bot sit for an extended period of time the glue in the bottle will harden and can cause clogs. If you use the Gl&uuml;Bot a lot you don't have to worry about this. A pin can be used to break up any clogs in the tip if you have not used the bottle in a while.</p>