Engraving .063 (14 Ga.) Aluminium Blanks - Beyond the Manual - Glowforge Owners Forum

I’m having trouble finding the correct settings to use to engrave some metal blanks I have. They should be fine to work with, but it’s like the laser doesn’t know it is there. I can put any other material in its place (it appears) and it will engrave it fine. I tried full power, 70%, 30% and different speeds. So far, no luck. Any advice would be welcome!

Question: Are there other unsafe materials besides green-flame chlorine, what about reflective metals? - Beyond the Manual - Glowforge Owners Forum

Won't engrave where I put the design - Community Support - Glowforge Owners Forum

Engraving AR mag - #19 by henryhbk - Beyond the Manual - Glowforge Owners Forum

3mm Felt Engraving - Beyond the Manual - Glowforge Owners Forum

Xtool UTILITY D1 Pro Machine Stand With Honeycomb Cm Inches DIY Laser Cut Files Dxf Svg Lightburn

Engraving on material greater than 0.5” - Community Support - Glowforge Owners Forum

Advice on Metals and the Glowforge - Beyond the Manual - Glowforge Owners Forum

Engraving Aluminum - Beyond the Manual - Glowforge Owners Forum

Mirror Engrave (Success on my 1st Try) - Beyond the Manual - Glowforge Owners Forum