54mm 3D Printed Thrust Ring Thrust Rings 3D printed plastic thrust ring designed to be bonded to a 54mm O.D. single-use motor casing for motor retention. To use, the nozzle is installed in the casing and epoxy is dispensed into the gap between the nozzle and the case until the level of epoxy rises to just below the end of the case. The thrust ring is then placed over the nozzle and pushed onto the end of the case until fully seated. The inner ring becomes embedded in the epoxy when cured, and the slight angle in the inner ring creates a physical restriction that prevents it from being ejected under pressure. As the thrust ring is pushed onto the case, the inner ring displaces some of the epoxy adhesive upward into the gap between the ring and the nozzle, increasing the length of the bond. Epoxy also flows into the gap between the inner ring and the case. This epoxy is allowed to cure before proceeding to the next (optional) step. Most of the inside length of the outer ring is designed to be slightly larger than the case wh
75mm Min Diameter Motor Retainer
Peak of Flight Newsletter : Apogee Rockets, Model Rocketry Excitement Starts Here
3D printed plastic thrust ring designed to be bonded to a 38mm O.D. single-use motor casing for motor retention. To use, the nozzle is installed in
38mm 3D Printed Thrust Ring
3D printed plastic thrust ring designed to be bonded to a 54mm O.D. single-use motor casing for motor retention. To use, the nozzle is installed in
54mm 3D Printed Thrust Ring
Umikot - large handle + roller bearings between spin ring and upper mech by flatpackrs, Download free STL model
54mm 3D Printed Thrust Ring
HAMR Motor Adapter - Rocketry Works
Thrust Rings
Shock Cord Anchor for 54mm Tube
umikot 3D Models to Print - yeggi
54mm 3-Grain Single-Use EMK™ High Power Experimental Motor Kit
Yet Another) 100k Attempt, Page 2
Shop tapered roller bearing with fast delivery and free shipping. Tapered roller bearing for high reliability and good performance.
thrust tapered roller bearing F-564365.AR 54mm X 82mm X 22mm
Motor Adapter by Aeropack
This kit includes all parts needed to construct a 54mm diameter 2-grain high power single use motor using your own epoxy, propellant and delay grains
54mm 2-Grain Single-Use EMK™ High Power Experimental Motor Kit